Filter
Top Products
48
Automatic Route Selection
To store the carrier code
1 Press .
2 Press or until the arrow points
to “Setting Base”, then press .
•“Input Command” is displayed.
3 Press
.
4 Enter the 4-digit base unit PIN (p. 55).
5 Press .
•The current setting is displayed.
0: OFF (factory preset) 1: ON
6
Press to select ON and the 1st carrier
code setting.
7 Enter the carrier code, up to 7 digits.
8 Press .
•A beep sounds.
•To
continue storing area code(s), enter the
command .
•To return to the standby mode, press .
2
1
1
9
To store the area code(s)
1 Press .
2 Press or until the arrow points
to “Setting Base”, then press .
•“Input Command” is displayed.
3 Press
.
4 Enter the 4-digit base unit PIN (p. 55).
5 Press .
6 Enter the area code, up to 5 digits.
7 Press .
•A beep sounds.
•“02” is displayed. To continue entering
another area code, enter the next number,
then press .
8 Press .
•To return to the standby mode, press
.
2
9
To turn OFF the ARS mode
Follow steps 1 to 5, then press to select
OFF in step 6. When finished, press ,
then .
0
Storing the Carrier Code/Area Code(s)
Make sure that the power is ON (p. 11) and the unit is in the standby mode.
Input Command
91 0
Input Command
92 01-
TCD715NLM(E)-6Advance1 01.9.17 8:16 PM Page 48