Panasonic KX-TCD715NLM Telephone User Manual


 
Ni-Cd battery operating time (optional)*
Up to about 12 hours(based on 800mA per hour)
Up to about 100 hours
11
Chapter 1
Preparation
Battery information
After your Panasonic batteries are fully charged:
Battery
Operating time may be shortened depending on usage conditions, such as:
when viewing the Caller ID Caller List or phonebook,
when talking in speakerphone mode, and
ambient temperature.
Clean the handset and the base unit charge contacts with a soft, dry cloth once a month.
Clean more often if the unit is subject to grease, dust or high humidity. Otherwise the batteries
may not charge properly.
If the batteries are fully charged, you do not have to place the handset on the base unit until
“” flashes. This will maximize the battery life.
The batteries cannot be overcharged.
*
Nickel cadmium (Ni-Cd) rechargeable batteries (AA size) are available.
When you replace the batteries, you must program the battery type selection (see page 70).
Operation
While in use (Talk)
While not in use (Standby)
Ni-MH battery operating time (included)
Up to about 20 hours
Up to about 200 hours
Base 1
10 New Calls
12.05 13:58
Turning the Power ON
# The current connected base unit number:
You can choose whether to display the base
unit number, handset number or no display
in the standby mode by programming (p. 64).
$ The number of new Caller ID calls received
(p. 24)
% The current date and time:
After you set the date and time, the current
date/time will be displayed (p. 17).
To turn the power OFF
, press and hold
until a beep sounds.
The display will go blank.
The handset will not ring.
Press and hold .
After all the possible configurations briefly
appear, the display will change to the following.
Then the handset is in the standby mode.
#
$
%
TCD715NLM(E)-1Preparation1 01.9.17 8:07 PM Page 11