Filter
Top Products
30
Storing Names and Numbers in the Phonebook
After caller information is categorized in the phonebook, you can select the backlight color and ringer
type for each private category (p. 34).
Make sure that the power is ON (p. 11) and the unit is in the standby mode.
1 Press .
2 Press or until the arrow points
to “New Phonebook”, then press .
•The display shows the number of
remaining phonebook items then
“<Enter Name>”.
3 Enter a name, up to 16 characters with
the dialing buttons, , or .
•See steps for entering names and symbols
(p. 31).
4 Press .
C
6 Press .
7 Press or to select Private
category number (1–9) or OFF, then
press .
8 While “Save” is at the arrow,
press .
•A beep sounds and “Saved” is displayed.
•The display will return to “<Enter
Name>”. You can continue storing other
items.
•To return to the standby mode, press
.
•If the display shows “Memory Full” in step
2, the display will return to the standby mode.
Clear other stored items in the phonebook
(p. 36).
Enter
New Phonebook
200—Memory Avail
<Enter Name>
5 Enter a phone number up to 24 digits.
•If you misdial, press . Digits are
erased from the right. To erase all digits,
press and hold .
C
C
Eva Sch tz
<Enter Phone No>
Private Category
H
OFF
Category 1
Using the Phonebook
TCD715NLM(E)-4Basic2* 01.9.17 8:13 PM Page 30