Filter
Top Products
1212
Enter a desired function command as shown on the next page.
You can program the following function items using the handset near the base unit. The display
shows the instructions. After selecting “
Setting Base”, enter the desired function command
(p. 13). See the corresponding pages for function details.
Make sure that the power is ON (p. 11) and the unit is in the standby mode.
New Phonebook
Setting Handset
H
Setting Base
<Standby mode>
<Function menu>
*
Press .
Base 1
12 New Calls
12.05 13:58
Press .
Summary of Programmable Functions
To store names and numbers in the phonebook (p. 30)
To set the handset programming (p. 14)
Input Command
While programming:
*
To select a desired function item, press or until the arrow points to the item. Then press
to go to the next step.
•You can press to go to the next menu of the function menu instead of pressing .
•To return to the previous step during programming, press or .
•You can exit the programming mode any time by pressing and also can return to
Function menu by pressing .
•When programming is completed, a beep sounds.
C
C
TCD715NLM(E)-2Preparation2 01.9.17 8:09 PM Page 12