Filter
Top Products
45
Chapter 3
Advanced Operations
7 Enter a call restriction number, up to 8
digits.
•If you misdial, press . The digits are
erased from the right. To erase all digits,
press and hold .
8 Press .
•A beep sounds.
•“2” is displayed. To continue entering a
number, enter the next number, then press
.
9 Press .
•To return to the standby mode, press
.
C
C
1 Press .
2 Press or until the arrow points
to “Setting Base”, then press .
•“Input Command” is displayed.
3 Press .
4 Enter the 4-digit base unit PIN (p. 55).
•The current registered handset
number(s)/base unit is/are displayed.
•The base unit number is displayed as “0”.
5 Enter the handset number(s)/base unit
which you want to restrict.
•The selected handset number(s)/base unit
flash(es).
•If you misdial, press the number(s) again.
6 Press .
•“1” is displayed.
6
Call Restriction
You can restrict desired handset(s)/base unit from dialing selected phone numbers. Phone numbers
beginning with the restricted digits cannot be dialed out. For example, if “00” is assigned as the call
restriction number, international calls cannot be made.
For selected handset(s)/base unit, you can assign up to 6 call restriction numbers (up to 8 digits). Set
the call restricted handset(s)/base unit and the restriction number(s) by programming. The factory
preset is OFF.
Make sure that the power is ON (p. 11) and the unit is in the standby mode.
Input Command
6 2-
Input Command
6 0123456
Input Command
6 1-
TCD715NLM(E)-6Advance1 01.9.17 8:16 PM Page 45