Panasonic KX-TCD715NLM Telephone User Manual


 
43
Chapter 3
Advanced Operations
Direct Call
1 Press .
2 Press or until the arrow points
to “Setting Handset”, then press
.
3 Press or until the arrow points
to “Call Option”, then press .
4
Press or until the arrow points to
Direct Call No.”, then press .
<Enter Phone No> is displayed.
5 Enter the phone number up to 24 digits.
If you misdial, press . The digits are
erased from the right. To erase all digits,
press and hold .
6 Press .
7 While the arrow is at “Save”, press .
8 While the arrow is at “ON”, press .
A beep sounds.
C
C
Base 1
10 New Calls
You can easily make a call using a stored direct call number by pressing or . Incoming
calls are accepted. To use this feature, store the direct call number and turn on the mode by
programming. The factory preset is OFF.
Setting the Direct Call Number and Mode
After storing the direct call number, the unit will automatically switch to the direct call mode. When the
direct call mode is on, you can ONLY dial the number stored in the direct call memory.
Make sure that the power is ON (p. 11) and the unit is in the standby mode.
To turn OFF/ON the direct call
mode
Follow steps 1 to 3. In step 4, press or
until the arrow points to “Direct
ON/OFF”, press . Press or to
select OFF or ON and press . When
finished, press .
When set to off, “ ” will go out.
Dialing the Stored Number
Make sure that “ ” is displayed, then press or .
The number stored in the direct call memory is dialed automatically.
9 Press to return to the standby
mode.
The handset is now in the direct call
mode.
TCD715NLM(E)-6Advance1 01.9.17 8:16 PM Page 43