Filter
Top Products
RTU-292 Operations Manual
7.2 VOICE PROMPT OPTION
When the Voice Prompt Option is installed, the RTU-292 will send helpful prompts to system
users to guide them in proper system operation and inform them of the current system status.
The standard language is female English, though other languages and genders may be
purchased, an additional fee to create the non-standard prompts is charged. Contact JPS for
details.
7.2.1 INSTALLATION AND CONFIGURATION
The Voice Prompt Option is a small PCB that is installed to four threaded standoffs in the
options tray, with a 20-wire cable from the option to connector J7 on the Options Interface
board, which is also installed in the options tray. Figure 7.1 shows correct option placement in
the options tray.
After the Voice Prompt option is installed, the main CPU must be informed by switching on the
Voice Prompts Enable dipswitch, SW1-6 on the Main Board. Remember that this switch is
only read at unit power-up. No other configuration settings or adjustments are required.
Table 7-2 Voice Prompts Enable
SW1-6 Voice Prompts
Off Disabled
On Enabled
7.2.2 OPERATION
Since the Voice Prompt Option is very commonly used, its operational instructions are included
in section 3, RTU-292 Operation. Theory of Operation information is included in section 4.
JPS Communications, Inc.
7-2