Filter
Top Products
RTU-292 Operations Manual
2.8.12 PASSWORD PROTECTION
Dipswitch SW1-5 enables or disables the RTU-292's password protection feature. Password
protection prevents unauthorized access to the system from the PSTN line when the RTU-292
is in the Automated Operation Mode. (See section 3.7 for a full explanation of Automated
Mode Operation and the use of the Password Protection Feature). The factory setting is
disabled, SW1-5 Off. To enable the password protection feature, turn SW1-5 On. The factory
default password is “1 2 3 4”, but may be changed to any number up to 10 digits long. See
Table 3-2.
Table 2-10 Password Protection
SW1-5 Passwords
Off Disabled *
On Enabled
2.8.13 VOICE PROMPTS
Dipswitch SW1-6 enables or disables the use of Voice Prompts in the RTU-292. This feature
should be enabled only if the Voice Prompt Option is installed. See section 3.7 for an
explanation of the Voice Prompt feature operation, and section 7.2 for field installation. The
factory default setting: disabled if the Voice Prompt Option is not installed and enabled if it is.
Table 2-11 Voice Prompts Enable
SW1-6 Voice Prompts
Off Disabled
On Enabled
2.8.14 LOCAL PHONE / LOCAL PHONE RING-THROUGH
Dipswitch SW1-7 enables or disables the RTU-292 Local Phone Option. This feature should
be enabled only if the Local Phone Option is installed. The factory setting is: Disabled (SW1-7
Off) if the Local Phone Option is not installed and enabled (SW1-7 On) if it is. See section 3.7
for an explanation of Local Phone Option operation, and section 7.3 for field installation
instructions.
SW1-8 enables the Local Phone Ring-Through feature. This causes the local phone to ring
whenever a call is received by the RTU-292 via the PSTN input. When disabled, the local
phone may still be used to send and receive calls, but will not ring when a call is received. Set
SW1-8 to On to enable Local Phone Ring-Through, and Off to disable this feature. This switch
should always be set to Off (disabled) when the Local Phone Option is not installed. The
factory setting is On (enabled) when the Local Phone Option is installed and Off (disabled)
otherwise.
JPS Communications, Inc.
2-10