Filter
Top Products
5330/5340 IP Phones – User Guide
To delete a particular call from the call log:
• With the call log that you want to delete displayed, press Yes twice or press the Delete
softkey.
Call Park
The Call Park feature allows you to place a call in a special hold state. You, or someone else, can
then retrieve the call from any extension in the system.
After parking the call, the system can automatically connect you to paging equipment so that you
can announce the call to the requested party.
To park an active call:
1. Do one of the following:
• Press the Call Park feature key (must be programmed)
• Press (TRANS/CONF), and then dial the appropriate feature access code.
The display shows PARKED@, followed by the park destination and parking spot
index (if applicable). Example: PARKED@ 1234 @ 02.
2. Dial the directory number on which to park the call (not required if the number is
programmed to the Call Park feature key).
3. To inform a user that a parked call is waiting, do one of the following:
• If automatic paging is enabled, announce the call and the park retrieve digits
shown on the display.
• If automatic paging is disabled, press the programmed Page key, or dial the
appropriate feature access code, followed by the Paging zone number (if
required). Then, announce the call and park retrieve digits shown on the display.
Note: Paging over a loudspeaker is not permitted in handsfree mode; you must use the handset or
headset.
To retrieve a parked call:
1. Do one of the following:
• Dial the appropriate feature access code.
• Press the Call Park - Retrieve feature key (must be programmed).
2. Dial the directory number on which the call is parked (not required if the number is
programmed to the Call Park feature key).
3. If there are multiple calls parked on the number, dial the two-digit index number to
retrieve a specific call, or # to retrieve the longest parked call.
61