Filter
Top Products
18
4
FREQUENCY SETTING
D Band selection
All HF ham bands and a general coverage receiver
band are included in the IC-718.
Push [∫ UP]/[√ DN] to select the desired band.
• Pushing [∫ UP]/[√ DN] continuously scrolls through the
available bands.
Note: For example, if 6.10000 MHz is resistered as
the General coverage frequency, then the General
coverage band automatically positions itself between
3.5 MHz and 7 MHz band.
D Programmable tuning steps
Programmable tuning steps are available to suit your
operating requirements.
These tuning steps are:
• Selectable from 0.1, 1, 5, 9, 10, 100 kHz
q
Push [TS], the programmable tuning step indicator,
“,” then appears above the 1 kHz.
• Rotating the tuning dial changes the frequency
according to the set tuning step.
w Push [TS] for 2 sec. while the programmable
tuning step indicator appears to enter the tuning
step set mode.
e Rotate the tuning dial to set the desired tuning
step.
r Push [TS] to exit the tuning step set mode.
t Rotate the tuning dial to change the frequency
according to the set tuning step.
Programmable tuning
step indicator
10 KHz tuning steps is
selected.
DN
UP
General (new)
General (old)
Y
Z
D Band stacking resister
The band stacking register automatically stores the
last frequency and mode used for each band. This
is convenient for contest operation, etc. The tables
below shows the band stacking register default
settings for each band.
BAND BAND BAND
1.9 MHz
1.91000 MHz CW
3.5 MHz 3.55000 MHz LSB
7 MHz
7.05000 MHz LSB
10 MHz 10.12000 MHz CW
14 MHz 14.10000 MHz USB
General 15.10000 MHz USB
BAND BAND BAND
18 MHz
18.10000 MHz USB
21 MHz 21.20000 MHz USB
24 MHz
24.95000 MHz
USB
28 MHz 28.50000 MHz USB
29 MHz 29.50000 MHz USB