Filter
Top Products
11 - 8 Dolphin® 9500/9550 Mobile Computer User’s Guide
Mobile Base Serial Connector
The following diagram displays the pin diagram of the serial connector of the bottom panel of the Mobile Base.
Note:
Signals referenced are for a DTE device.
The Mobile Base connector is straight to the printed circuit board (PCB). The ninth pin sends 500mA at 5V power out. This can
power a peripheral device, such as a mobile printer, as long as that peripheral device can accept 500mA at 5V.
Configuring the Dolphin Terminal
Communications Properties must be configured appropriately on the Dolphin 9500/9550 terminal for it to communicate with the
Mobile Base.
To set Communications Properties:
1. Tap Start > ActiveSync > Tools > Options.
2. Tap the PC Connection tab
3. Check the Enable Synchronization check box.