Filter
Top Products
Installing the Hub in a Rack
FastHub 400 10/100 Series Installation and Configuration Guide
2-8
Installing the Hub in a Rack
This section describes how to install the hub in 19- and 24-inch standard and telco racks.
Note Be sure the hub is powered off and is not connected to a power source before you
perform the steps in the sections that follow.
Attaching the Brackets to the Hub
The bracket orientation and the screws you use dependon whether you plan touse a 19-inch
or a 24-inch rack:
• For a 19-inch rack-mount, use the Phillips flat-head screws to attach the long side of the
bracket to the hub.
• For a 24-inch rack-mount, use the Phillips truss-head screws to attach the short side of
the bracket to the hub.
Place the hub on a level surface, and use two of the supplied Phillips flat-head or truss-head
screws to attach a mounting bracket to each side of the hub.
Figure 2-1, Figure 2-2, and Figure 2-3 show how to attach one bracket to one side of the
hub. Follow the same steps for the opposite side of the hub.
Figure 2-1 Attaching Brackets for 19- and 24-inch Racks (Front Panel Forward)
RPS
MODE
1x 2x 3x 4x 5x 6x 7x 8x
Phillips
flat-head
screws
19" configuration
H10730
RPS
MODE
1x 2x 3x 4x 5x 6x 7x 8x
H10731
Phillips
truss-head
screws
24" configuration