Filter
Top Products
Installing and Starting Up the Hub 2-23
Accessing the CLI
Accessing the CLI
You can access the CLI
• From a console terminal connected to the hub console port. For more information, see
the “Connecting to the Console Port (FastHub 400M Models)” section on page 2-14.
• Through a Telnet session from a remote host by entering the telnet command and the
name or IP address of the hub.
• Through a Telnet session by clicking Telnet on the hub manager Home Page.
When you access the CLI and a password has been defined, the following prompt is
displayed:
Cisco Systems Console
Enter Password:
Enter the password. The hostname> prompt is displayed after you enter the correct
password.
For complete information about the CLI, refer to the FastHub 400 10/100 Series Command
Reference.
Accessing the MIB Files through SNMP
Youcan access the hub MIBfiles through SNMP. The following MIB files containvariables
that can be set or read to provide information about the hub and the traps generated by the
hub.
• RFC1213-MIB.my contains the MIB II (RFC 1213).
• ETHERLIKE-MIB.my contains the Ethernet Transmission MIB (RFC 1643).
• CISCO-CDP-MIB.my contains the CDP MIB.
• SNMP-REPEATER-MIB.my contains the standard MIB for managing the hub.
• RMON-MIB.my contains the RFC 1757 RMON (Groups 1, 2, 3, and 9). More
information about RMON and the RMON groups is provided in the “Remote
Monitoring” section on page 2-25.
• CISCO-SIBU-SIMPLE-UPGRADE-MIB.my contains the MIB module for upgrading
the firmware on Cisco low-end devices.