Filter
Top Products
Installing and Starting Up the Hub 2-21
Accessing the FastHub 400 Series Hub Manager
Accessing the FastHub 400 Series Hub Manager
To access the hub manager, all you need is the IP information of the hub (and the password
if one has been assigned). IP information for the hub is usually assigned when the hub is
first started up after installation. (See the “Assigning IP Information to the Hub (FastHub
400M Models)” section on page 2-16.)
Note You can access the hub manager from a PC connected to one of the 10/100 ports.
Therefore, make sure that you do not disable or otherwise misconfigure the port through
which you are communicating with the hub. You might want to write down the port number
to which you are connected. Make changes to the hub IP information with care.
To access the hub manager, follow these steps:
Step 1 Start Netscape Communicator (4.03 or higher) or Microsoft Internet Explorer
(4.01 or higher).
Step 2 Ensure that the following browser features are enabled:
• Java
• JavaScript
• Set the caching of pages to Every time in Communicator or
Every visit to the page in Internet Explorer.
Step 3 Enter the IP address of the hub in the Location field if you are using
Communicator (the Address field if you are using Internet Explorer) to display
the hub manager Home Page (Figure 2-10).
11187