Filter
Top Products
Installing and Starting Up the Hub 2-15
Connecting to the Console Port (FastHub 400M Models)
Step 2 Connect one end of the supplied rollover console cable to the console port, as
shown in Figure 2-8.
Caution Do not connect an actual telephone line, an ISDN line, or an Ethernet cable to
this console port. Damage to the hub can result. Make sure you use the supplied
RJ-45-to-RJ-45 rollover cable and adapters to connect the console port to the management
station or modem.
Figure 2-8 Connecting to the Console Port
Step 3
Attach the appropriate adapter, such as the supplied RJ-45-to-DB-9 female DTE
adapter (labeled Terminal), to a management station or modem.
Note If you are connecting the hub to a Sun workstation (or to a management
station with a female DB-25 serial connector), use a male-to-male gender
changer to attach the supplied RJ-45-to-RJ-45 rollover cable and a
RJ-45-to-DB-25 female DTE adapter to the management station.
Step 4 Connect the other end of the supplied rollover cable to the adapter.
Connector and cabling specifications for the console port are in the Appendix B,
“Connector and Cable Specifications.”
Now that the hub is connected to a management station, you can assign IP information to
the hub (see the “Assigning IP Information to the Hub (FastHub 400M Models)” section on
page 2-16).
RATING
100-127 / 200-240 V~
2A /1A 50 / 60 Hz
CONSOLE
UP
MEDIA MODULE
DOWN
DC INPUT
DC INPUTS FOR REMOTE
POWER SUPPLY
SPECIFIED IN MANUAL
+5V
@
6A, +12V
@
1A
Supplied RJ-45-to-RJ-45
rollover console cable
14256