Filter
Top Products
Accessing the Management Interfaces (FastHub 400M Models)
FastHub 400 10/100 Series Installation and Configuration Guide
2-20
Step 2 Connect the other end of the cable to the 10BaseT or 100BaseTX port of the
network device.
Step 3 Check to see that the port LED for the port that you connected in Step 1 comes
on.
If the port LED does not come on, check for the following problems:
• The network device is not turned on.
• The Ethernet adapter in the network device is not operating correctly.
• You are using the wrong type of Ethernet cable.
• The Ethernet cable is damaged or not connected correctly.
Step 4 If required, reconfigure and reboot the connected network device.
Step 5 Repeat Steps 1 through 3 for each device that you are connecting to the hub.
If you need more information about Ethernet cabling and 10/100 port pinouts, refer to
Appendix B, “Connector and Cable Specifications.”
Accessing the Management Interfaces (FastHub 400M
Models)
After you assign IP information to the hub, you can access the hub management interfaces.
This section provides information for accessing the FastHub 400 series Hub Manager, the
CLI, and SNMP and MIB files.