Filter
Top Products
Accessing the Management Interfaces (FastHub 400M Models)
FastHub 400 10/100 Series Installation and Configuration Guide
2-24
• CISCO-SIBU-MANAGERS-MIB.my contains the MIB module for management
interfaces on the FastHub 400M models.
• CISCO-SIBU-STACKABLE-DUAL-SPEED-HUB-MIB.my contains the MIB module
that extends the REPEATER-MIB to manage Cisco low-end stackable repeater
products.
If you are going to manage the hub by using SNMP and the MIB files, the Read and Write
community strings need to be set. To do this, you can either
• Use the default community strings
— Read community string. The default is public.
— Write community string. The default is private.
• Assign community strings by using the SNMP Management Page or by using the
snmp-server community command on the CLI.
Note Wait approximately 30 seconds for the changes to be saved to permanent storage
before turning off the hub, or the changes might not be saved.
You can obtain a copy of the MIB files in the following ways:
• Using File Transfer Protocol (FTP) to access the ftp.cisco.com server.
• Using Cisco Connection Online (CCO) to access the cisco.com server.
Using FTP to Access the MIB Files
To obtain a MIB file, follow these steps:
Step 1 Use FTP to access the server ftp.cisco.com.
Step 2 Log in with the username anonymous.
Step 3 Enter your e-mail name when prompted for the password.
Step 4 At the ftp> prompt, change directories to /pub/MIBs.
Step 5 Use the get README command to display the readme file listing available
files.
Step 6 Use the get MIB_filename command to get a copy of the MIB file.