Filter
Top Products
Installing and Starting Up the Hub 2-17
Assigning IP Information to the Hub (FastHub 400M Models)
Step 5 Enter the IP address of the default gateway (for example: 10.1.105.254):
Enter IP default gateway: 10.1.105.254
Note If the management station from which the FastHub 400 series Hub
Manager is used is not on the same IP subnet as the hub, you must also assign a
default gateway (the router for the local subnet).
The following information is displayed:
The following configuration command script was created:
ip address 10.1.105.20 255.255.255.0
ip default-gateway 10.1.105.254
!
end
Step 6 Enter Y:
Use this configuration? [yes/no]: Y
The following information is displayed:
Building configuration...
Use the enabled mode ‘configuration’ command to modify this
configuration.
Press RETURN to get started.
Pressing Return opens a CLI session.
Step 7 Exit from the terminal session.
You can now use the hub with its default values or configure and monitor it by using the
FastHub 400 series Hub Manager, the CLI, or SNMP and the MIB files.