Filter
Top Products
FortiGate Voice VoIP, PBX, and PSTN CLI Reference config system pstn
FortiGate Voice Version 4.0 MR1 Administration Guide
01-410-112851-20100601 57
http://docs.fortinet.com/ • Feedback
config system pstn
Use this command to configure the PSTN interfaces. PSTN interfaces are available on
some FortiGate Voice models.
Syntax
config system pstn
edit <fxo_name>
set cid-name <caller_name>
set cid-number <caller_name>
set status {enable | disable}
set user-callerid {enable | disable}
set cid-signalling {bell | dtmf | v23 | v23-jp}
set cid-start {polarity | ring}
set send-callerid-after <integer>
set hangup-on-polarity-reversal
set hangup-on-zero-voltage
set hangup-on-busy-tone
set busycount <integer>
set busy-tone-length <integer>
set busy-quiet-length <integer>
set codec {alaw | ulaw}
end
Variables Description Default
edit <fxo_name> Enter the name of the FXO. No
default
cid-name
<caller_name>
This name is used for caller ID for calls from the FortiGate
Voice unit to the PSTN. It can be any name, such as a
company name, that identifies the branch office.
No
default
cid-number
<caller_name>
Enter the phone number of the PSTN phone line as
provided by your phone service provider.
No
default
status
{enable | disable}
Enable the status of the port. No
default
user-callerid
{enable | disable}
Enable to catch the caller ID. No
default
cid-signalling {bell
| dtmf | v23 |
v23-jp}
Enter the caller ID protocol. The protocol v23-jp is the v23
protocol for Japan.
No
default
cid-start
{polarity | ring}
Enter to start transmitting the caller ID. No
default
send-callerid-after
<integer>
Enter a number for the number of rings after that the caller
ID began to transmit.
No
default
hangup-on-polarity-
reversal
Enter to have the phone hang up when there is polarity
reversal.
No
default
hangup-on-zero-
voltage
Enter to have the phone hang up when there is zero
voltage.
No
default
hangup-on-busy-tone Enter to have the phone hang up when a busy tone is
detected.
No
default
busycount <integer> Enter a number for the accurate number of busy tones that
are detected.
No
default