Filter
Top Products
B-1
Ericsson MD-110 Serial Integration Guide
OL-1290-01
APPENDIX
B
Assigning Dialogic Ports for a Dual
Phone System Integration
In a dual phone system integration, Cisco Unity assigns a voice messaging port to
the traditional phone system for every port available on the installed voice cards
before assigning voice messaging ports to Cisco CallManager. The result is that
Cisco Unity may not have enough voice messaging ports remaining to assign to
Cisco CallManager.
The maximum number of voice messaging ports are assigned to the traditional
phone system in spite of the settings on the Ports page in the System
Administrator.
For example, a dual phone system integration might have the following
configuration:
• A traditional phone system has a four-port voice card installed.
• Cisco CallManager has six Voice Mail ports set up.
• The Cisco Unity server has a system key enabled for a total of eight ports.
• The Ports page on System Administrator indicates that Ports 1 and 2 are
assigned to the traditional phone system and Ports 3 through 8 are assigned
to Cisco CallManager.
Even so, Ports 1 through 4 (the total voice card ports) will be assigned to the
traditional phone system, and Ports 5 through 6 will be assigned to Cisco
CallManager.
If you want to assign fewer than the total voice card ports to the traditional phone
system, you must first set the Port assignments on the Ports page of the System
Administrator, then perform the following procedure.