Filter
Top Products
Chapter 2 Dual Phone System Integration
Changing the Number of Installed Ports
2-8
Ericsson MD-110 Serial Integration Guide
OL-1290-01
Step 2 For each device, in the Switch list select the phone system that Cisco Unity uses
to dial out when notifying subscribers of new messages. Each notification device
can be associated with a specific phone system (except for text pagers).
Cisco Unity uses the phone system specified on the subscriber template’s Profile
page as the default.
Step 3 Adjust other settings as appropriate. For more information, see the online Help in
the Cisco Unity Administrator.
Caution The selected phone system must have at least one port set to dial out for
message notifications on the System > Ports page. If the selected phone system
does not have any ports set for this function, notifications will fail.
Changing the Number of Installed Ports
After the dual phone system integration is set up, if you need to add or remove
voice cards or uninstall voice card software, follow these steps:
1. Remove the existing AV-Cisco TAPI service provider. For details, see the “To
remove the existing AV-Cisco TSP” section on page 2-9.
2. As appropriate, remove or add voice cards, or uninstall and reinstall the voice
card software. For information about removing Dialogic voice card software,
refer to the chapter “Adding, Changing, or Removing Voice Cards” in the
Cisco Unity Installation Guide.
3. Reinstall the AV-Cisco TAPI service provider after you have set up the voice
cards or reinstalled the voice card software. For details, see “To reinstall the
AV-Cisco TAPI service provider” section on page 2-9.
4. Adjust the port assignments on the System > Ports page. The voice messaging
ports must appear in this order in the list of ports: first are all the ports
connected to the traditional phone system, second are the ports connected to
CallManager.