Filter
Top Products
2-7
Ericsson MD-110 Serial Integration Guide
OL-1290-01
Chapter 2 Dual Phone System Integration
Changing Cisco Unity Administrator Settings
To select which phone system subscribers and call handlers use
For existing subscriber templates, subscriber accounts, and call handlers,
Cisco Unity uses the traditional phone system as its default. Therefore, during the
initial setup of the dual phone integration, you will modify only those pages that
will be using Cisco CallManager. Note that changes made to subscriber templates
do not affect existing subscriber accounts.
Step 1 In Cisco Unity Administrator, go to the appropriate page:
• Subscribers > Subscriber Template > Profile
• Subscribers > Subscribers > Profile
• Call Management > Call Handlers > Profile
Step 2 In the Switch list, select the appropriate phone system.
Step 3 Adjust other settings as appropriate. For more information, see the online Help in
the Cisco Unity Administrator.
Caution If the Switch setting on the Profile page for the subscriber or call handler does
not match the phone system actually used by a subscriber or call handler,
Cisco Unity will not be able to transfer calls to or from the subscriber or call
handler. Additionally, Cisco Unity will be unable to turn the MWIs for the
subscriber on or off and will be unable to reach the extension for the subscriber
when recording by phone with Media Master.
To select which phone system Cisco Unity uses for message notification
If subscribers use message notification, you can select which phone system
Cisco Unity dials out on when notifying subscribers of new messages. Note that
changes made to subscriber templates do not affect existing subscribers.
Step 1 In Cisco Unity Administrator, go to the appropriate page:
• Subscribers > Subscriber Template > Message Notification
• Subscribers > Message Notification.