Filter
Top Products
1-11
Ericsson MD-110 Serial Integration Guide
OL-1290-01
Chapter 1 Ericsson MD-110 Serial Integration
Testing the Integration
Step 10 Confirm that the MWI on Phone 1 is activated. The activated MWI means that the
phone system and Cisco Unity are successfully integrated for turning on MWIs.
To test an internal call with release transfer
Step 1 From Phone 1, enter the internal pilot number for Cisco Unity.
Step 2 When asked for your password, enter 12345. Hearing the request for your
password means that the phone system sent the necessary call information to
Cisco Unity, which correctly interpreted the information.
Step 3 Confirm that you hear the recorded voice name for Example Subscriber. Hearing
the voice name means that Cisco Unity correctly identified the subscriber by the
extension.
Step 4 When asked whether you want to listen to your messages, press 1.
Step 5 After listening to the message, press 3 to delete the message.
Step 6 Confirm that the MWI on Phone 1 is deactivated. The deactivated MWI means
that the phone system and Cisco Unity are successfully integrated for turning off
MWIs.
Step 7 Hang up Phone 1.
Step 8 On the Status Monitor, confirm that the state of the port handling the call changes
to “Idle.” This state means that the port was successfully released when the call
ended.
To set up supervised transfer on Cisco Unity
Step 1 In the Cisco Unity Administrator, go to Subscribers > Subscribers > Call
Transfer.
If Example Subscriber is not displayed, click the Find icon (the magnifying glass)
in the title bar, then click Find, and select Example Subscriber in the list that
appears.
For more information on transfer settings, refer to the “Subscriber Template Call
Transfer Settings” section in the Help for the Cisco Unity Administrator.
Step 2 Under Transfer Type, click Supervise Transfer.