Filter
Top Products
2-5
Ericsson MD-110 Serial Integration Guide
OL-1290-01
Chapter 2 Dual Phone System Integration
Changing Cisco Unity Administrator Settings
Step 3 Adjust other settings as appropriate. For more information about the other settings
on the Switch page, see the online Help in the Cisco Unity Administrator.
Step 4 Click the Save icon, then click OK in the Warning dialog box.
To specify switch settings for Cisco CallManager
Step 1 Go to System > Switch > IP Switch.
Step 2 In the Set Active Switch Type section, enter values as shown in the following
table:
Step 3 Click Set As Active, then click OK in the Warning dialog box.
Step 4 In the Access Code field, enter the trunk access code that Cisco Unity must dial
to transfer calls to the traditional phone system from Cisco CallManager.
The access code is the same number that subscribers on Cisco CallManager dial
to reach someone on the traditional phone system.
Step 5 Click the Save icon, then click OK in the Warning dialog box.
To modify voice port settings
Step 1 Go to System > Ports.
Table 2-1 Switch Settings
Switch Parameter Required Setting
Manufacturer Cisco
Model CallManager
Switch PBX software version 3.01 or later
Integration TAPI