Filter
Top Products
2-3
Ericsson MD-110 Serial Integration Guide
OL-1290-01
Chapter 2 Dual Phone System Integration
Changing Cisco Unity Administrator Settings
5. Change the Cisco Unity Administrator settings. See the “Changing
Cisco Unity Administrator Settings” section on page 2-3.
Requirements
The dual phone system integration supports configurations of the following
components:
• A Cisco Unity system key with the integration type set to “Multiple
integrations” and with the appropriate number of voice messaging ports
enabled.
• The Cisco Unity server set up and Cisco Unity 3.0(1) or later installed, as
described in the Cisco Unity Installation Guide.
• A traditional phone system installed and integrated with Cisco Unity. For
details, see Chapter 1 of this integration guide. The traditional phone system
(including the voice card software used in the integration) must be installed
and integrated with Cisco Unity before Cisco CallManager is integrated.
• Cisco CallManager, version 3.1(1) or later, and the AV-Cisco TAPI service
provider (TSP) installed and configured. For information about integrating
Cisco Unity with Cisco CallManager and the AV-Cisco TAPI Service
Provider, see the PDF of the Cisco CallManager Integration Guide, which is
located on the Cisco Unity Documentation compact disc.
Changing Cisco Unity Administrator Settings
After Cisco Unity is installed and the phone systems have been separately
integrated, you need to adjust settings on pages in the Cisco Unity Administrator
so that Cisco Unity can work with both phone systems.
Follow these steps to set up the dual phone system integration.
1. Specify settings for the traditional phone system on the System > Switch >
Switch page. For details, see the “To specify switch settings for the traditional
phone system” section on page 2-4.