Filter
Top Products
Chapter 1 Ericsson MD-110 Serial Integration
Programming the Phone System
1-8
Ericsson MD-110 Serial Integration Guide
OL-1290-01
Step 3 Use the GH command to create a hunt group for the voice messaging ports.
Make sure that the phone system sends calls only to Cisco Unity voice ports that
are set to Answer Calls on the System > Ports page in the Cisco Unity
Administrator. Calls sent to a voice port not set to Answer Calls cannot be
answered by Cisco Unity. And, if certain voice cards are installed, the call will not
be dropped, but the port remains unavailable for use until the Cisco Unity server
is restarted.
Step 4 Use the VMPOI command to associate the hunt group with Cisco Unity.
Step 5 Use the KS command to provide message waiting indication on DTS phones.
Step 6 Program each phone to forward calls to the pilot number assigned to the voice
messaging ports, based on one of the following Cisco Unity call transfer types.
Table 1-2 Call Transfer Types
Transfer type Usage
Release transfer
(blind transfer)
Program the phone to forward calls to the pilot
number when:
• The extension is busy
• The call is not answered
Supervised transfer Program the phone to forward calls to the pilot
number only when the call is not answered.
Confirm that call forwarding is disabled when the
extension is busy.