Filter
Top Products
26 OL-4637-03
Tips
• Calls must be on the same line before you can add them to a standard conference call. If calls are
on different lines, transfer them to a single line before using Confrn or Join.
• If you get an error stating, “No Participant Info” when attempting to use Join, be sure that you
have selected at least one call in addition to the active call, which is selected automatically.
• Depending on how your phone is configured, if you leave a conference after creating it, the
conference might end. See the last row of the above table for more information.
Starting or Joining a MeetMe Conference Call
MeetMe conferencing allows participants to join a conference by calling the conference number
directly, rather than waiting for the conference initiator to call them. See the table below for details.
Remove any conference
participant
Highlight the participant’s name and press Remove. You can remove
participants only if you initiated the conference call.
End your participation in a
standard conference
Hang up or press EndCall. If you did not initiate the conference call,
hanging up will not disrupt the connection for the remaining parties.
If you initiated the conference call, hanging up might end the
conference (depending on how your system administrator configured
your phone). To avoid this, you can transfer the conference to
another caller before hanging up. That caller then acts as the “virtual
controller” for the conference. A virtual controller cannot add or
remove parties; however, the conference continues with the
established participants.
If you want to... Then...
Establish a MeetMe
conference
Press NewCall or lift the receiver to go off-hook. Then press MeetMe
and dial the MeetMe conference number. (See your administrator for a
list of valid numbers.)
Remember to inform participants about the conference number, so that
they can dial in. However, participants will hear a busy tone if they call
the conference number before you have dialed in.
Participate in a MeetMe
conference
Dial the MeetMe conference number (provided by the conference
initiator). You will be connected to the conference only after the
conference initiator has dialed in.
End a MeetMe conference Hang up or press EndCall.
If you want to... Then...