Filter
Top Products
2-11
Cisco Unified IP Phone 7960G/7940G Administration Guide for Cisco Unified Communications Manager 7.0 (SCCP)
OL-15498-01
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
Using Cisco Unified IP Phones with Different Protocols
• To provision the phone manually, make the appropriate changes for SIP on the Phone Configuration
page in Cisco
Unified Communications Manager Administration. Refer to Cisco Unified IP Phone
7960G/7940G Administration Guide for Cisco Unified Communications Manager 7.0 (SIP).
Refer to Cisco Unified Communications Manager Administration Guide for detailed information about
Cisco Unified Communications Manager configuration. Refer to Cisco Unified Communications
Manager Bulk Administration Guide for detailed information about using the BAT.
Step 2 If you are not using DHCP in your network, configure the network parameters for the phone.
See the “Configuring Startup Network Settings” section on page 3-14.
Step 3 Power cycle the phone.
Converting an In-Use Phone from SCCP to SIP
You can use the Bulk Administration Tool (BAT) to convert a phone that is in use in your network from
SCCP to SIP. To access BAT from Cisco
Unified Communications Manager Administration, choose
Bulk Administration > Phones > Migrate Phones > SCCP to SIP. For detailed information, refer to
Cisco Unified Communications Manager Bulk Administration Guide.
Converting an In-Use Phone from SIP to SCCP
To convert a phone that is in use in your network from SIP to SCCP, perform these steps. For more
information, Cisco Unified
Communications Manager Administration Guide.
Procedure
Step 1 In Cisco Unified Communications Manager Administration, delete the existing SIP phone from the
Cisco
Unified Communications Manager database.
Step 2 In Cisco Unified Communications Manager Administration, create the phone as an SCCP phone.
Step 3 Power cycle the phone.
Tip Before deleting a SIP phone (that you want to convert to a SCCP phone) from the Cisco Unified
Communications Manager database, copy all of the phone configuration information, so when you add
the phone back to the database, you will have the configuration information readily available.
Deploying a Phone in an SCCP and SIP Environment
To deploy Cisco Unified IP Phones in an environment that includes SCCP and SIP and in which the
Cisco
Unified Communications Manager Auto-Registration parameter is SCCP, perform these general
steps:
1. Set the Cisco Unified Communications Manager Auto Registration Protocol enterprise parameter to
SCCP.