Filter
Top Products
The Battery Charger Installing the MDW 9040 Pocket Phone System 2
MDW Wireless Pocket Phone Installation and Use,
503-801-190 Issue 2, February 2001 29
3
To remove the battery pack, slide the spring latch upward (away from the battery
pack). Then, grasp both sides of the battery pack and gently pull the battery pack
upward and out.
Inserting the Handset into the Battery Charger’s Handset Cradle
Positioning and
Inserting the Handset
Correct positioning of the handset in the charger is important to ensure proper
charging:
1 Position the handset (with either battery pack attached) so that the two small
round holes in the bottom of the handset fit over the two guide pins on the bottom
of the handset cradle.
2 Rock the handset back into the cradle until it is firmly seated with the back of the
handset battery pack against the back of the handset cradle.
When the handset has been inserted correctly, the following occur:
• The HANDSET Battery Status LED lights.
• If the handset was off-hook, the OFF-HOOK icon in the display is no longer
visible.
• Any call that was in progress is terminated.