Filter
Top Products
How to Create an XML Application
G-40 41-001160-00, Release 2.1, Rev 04
IP Phone Administrator Guide
Appendix G
Execute Commands Object (for executing XML commands)
An AastraIPPhoneExecute object on the IP phones allows the phone to execute
commands using XML. The phones support the following execute object
commands:
• Reset - This command waits until the phone is idle and then executes a reset.
You can use this command in an XML script to enable the server to force
phone firmware changes and/or for troubleshooting purposes.
• NoOp - This command has no affect on the IP phone. It is made up of a blank
URI. You can use this feature when you need to press a key on the phone to
access a feature, and it is not necessary to display anything.
• FastReboot - This command allows an administrator to perform a fast reboot
of the IP phone when required.
• XML Softkey/Programmable Key LED Behavior - The URI=”Led:
<softkey or programmable key type>=<execute command>”/ controls the
behavior of XML softkey or programmable key LEDs. The softkey or
programmable key must be configured for XML before you enable this
feature.
The following paragraphs describe the AastraIPPhoneExecute object and the
commands you can use with this object.
AastraIPPhoneExecute Object Structure
The AastraIPPhoneExecute object describes the structure of the XML document
that you can use to send a command to the phone. It delivers multiple execution
requests to the phone. The basic structure of the AastraIPPhoneExecute object is:
<AastraIPPhoneExecute>
<ExecuteItem URI ="the URL or URI to be executed"/>
<! -- Additional execution items may be added under new ExecuteItem tag-->
</AastraIPPhoneExecute>
Note: For FastReboot commands, you must set the XML push server list
in the Aastra Web UI from where the XML HTTP post is being sent.