Open as PDF
Transfer a call
From the handset:
During a call, press INT. The outside call is put on hold automatically.
When you have only one system handset, your handset shows Calling
base and the telephone base rings and shows Handset is calling.
When you have more than one system handsets, the originating handset
shows INTERCOM TO:, press
or to select a destination and then
press the SELECT softkey.
If you are calling the telephone base, your handset shows Calling base
and the telephone base rings and shows Handset X is calling.
If you are calling another handset, your handset shows
Calling handset X and the destination handset rings and shows
Other handset is calling.
To answer the intercom call, press LINE 1 or LINE 2 on the telephone
base or press , , or INT on the handset. The outside call is still
on hold and both the originating handset and the destination handset
or the telephone base now show Intercom. You can now have a private
conversation between the handset and the telephone base or between the
Press OFF or the END softkey on the originating handset. Both screens
show Intercom ended.
The originating handset and the destination handset or telephone base
show L1)ON HOLD if the call is on line 1. Press on the destination
handset or press LINE 1 on the telephone base. The same procedures
apply if the call is on line 2.
If you want to cancel an intercom call and reconnect to the outside call
before the destination handset or telephone base answers, press the
corresponding line button,
on your originating handset.
If the destination handset or telephone base does not answer the intercom
call within 100 seconds, is in the directory or call log, or is out of range, your
originating handset shows Unable to call try again and the outside call
is still on hold. Press the corresponding line button,
to reconnect to the outside call.