Filter
Top Products
28
Answering system settings
Remote access code
A two-digit security code is required to access the answering system
remotely from any touch-tone telephone. The preset code is 19. You can set
the code to any number from 00 to 99.
To change the setting:
Using the telephone base:
Press the MENU softkey when the telephone base is not in use.
Press the SELECT softkey to select Answering sys.
Press /CID or /DIR to select Mailbox 1 or Mailbox
2,
then press the SELECT softkey. The corresponding
icon,
1
or
2, flashes on the screen.
Press /CID or /DIR to select Ans sys setup, then
press the SELECT softkey.
Press /CID or /DIR to select Remote code, then
press the SELECT softkey.
Use the dialing keys
(0-9)
to enter the code to any
number from 00 to 99.
Press CANCEL to delete
a digit.
P
ress
the SET softkey to confirm your setting or press
CANCEL to exit to the previous menu without making any changes.
Using the handset:
Press the MENU softkey when the handset is not in use.
Press the SELECT softkey to select ANSWERING SYS.
Press or to select Mailbox 1 or Mailbox 2, then press the SELECT
softkey. The corresponding icon,
1
or
2
, flashes
on the screen.
Press or to select Ans sys setup, then press the
SELECT softkey.
Press or to select Remote code, then press the
SELECT softkey.
Use the dialing keys to enter the code to any number
from 00 to 99.
Press OFF to delete a digit.
Then press
the SET softkey to confirm your setting or
press the BACK softkey to exit to the previous menu
without making any changes.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
6.
7.
1
BACK
SET
REMOTE CODE
__
1
BACK
SELECT
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
1
# of rings
Remote code
Msg alert tone
SELECT
1
REMOTE CODE
__
SET
If you change the remote access code setting on either Mailbox 1 or
Mailbox 2, it applies to both mailboxes in your answering system.