Filter
Top Products
www.uniden.com
[ 34 ] THE INTEGRATED ANSWERING DEVICE
Selecting the message Record Time
You have three record time options. The options “1 minute” or “4 minutes” set the duration for
recording the incoming messages. “
Announce only” answers the call with the preset greeting or
your personal greeting but prevents the caller from leaving a message.
1) Press the
menu/clock key four times in standby mode.
You hear “Record time” and the current recording time ([ ] 1 minute, [ ] 4 minutes, [ ]
Announce only, No recording), and it is displayed on the base.
Then you hear the guidance for setting the record time.
2) Press the
volume/select/ or volume/select/ key until the desired time appears.
3) Press the
set/ringer key to select the new recording time. You hear a confirmation tone, then
the announcement “Record time” and the new recording time is announced. After a few
seconds, the system announces “To set message alert, press menu again”.
▼Announce only feature
The announce only feature plays a prerecorded outgoing message “Hello, no one is available to take
your call. Please call again.”, and it will not allow the caller to leave a message. To set “Announce
only”, follow the steps above.
To scroll between the prerecorded message or your own personal greeting, press the
greeting key
when the outgoing message is played. If you want to use your own greeting, or want to omit the
prompt “to leave a message from your greeting”.
Refer to “Recording a personal outgoing message” (Greeting) on page 36.
Setting the Message Alert tone
Message Alert feature lets you know you have new messages by sounding a short beeping tone.
If you set the Message Alert to On and when a new message is received, the alert tone will
sound every 15 seconds.
1) Press the
menu/clock key five times in standby mode.
You hear “Message alert” and the current setting ([ ] Off or [ ] On), and it is displayed
on the base. Then you hear the guidance for setting the Message Alert.
After setting the
Announce only feature,
you may want to change
your outgoing message
not to prompt the caller
to leave a message.
However, the prerecorded
message changes
automatically.
EXAI398 2/5/3 4:12 PM Page 34