Filter
Top Products
www.uniden.com
GETTING STARTED [ 11]
GETTING STARTED
C. Connect the base unit
1) Connect the AC adapter to the DC IN 9V jack and to a
standard 120V AC wall outlet.
2) Set the base on a desk or tabletop, and place the
handset on the base unit as shown. (For wall mounting,
see "Mounting the Base Unit on a Wall", on page 12.)
3) Raise the antenna to a vertical position.
4) Make sure the
charge/in use LED illuminates. If the
LED does not illuminate, check to see that the AC
adapter is plugged in and the handset makes good
contact with the base charging contacts.
m
i
c
• Connect the AC adapter to a continuous
power supply.
• Place the base unit close to the AC outlet so that
you can unplug the AC adapter easily.
• After installing the battery pack in the handset, charge your handset at least
15-20 hours before plugging into the phone line.
• Use only the supplied
AD-314 AC adapter.
Do not use any other
AC adapter.
• Place the power cord so
that it does not create a
trip hazard or where it
could become chafed
and create a fire or
electrical hazard.
The handset can be placed
face up or face down on
the base for charging.
If your telephone outlet isn't modular, contact
your telephone company for assistance.
5) Once the handset battery pack is fully charged, connect
the telephone line cord to the
TEL LINE jack and a
telephone outlet.
Modular
EXAI398 2/5/3 4:11 PM Page 11