Filter
Top Products
www.uniden.com
[ 14 ] GETTING STARTED
4) Use the number keys (0 - 9), #/,
*
/tone
/,
or
delete/channel to
enter the 3-digit area code.
5) Press
select. A confirmation tone sounds and the displayed area code
is entered.
6) Press
end or return the handset to the base unit to complete the setting. The handset returns
to the standby mode.
When the area code has already been stored in memory, the stored area code
will be displayed. To change it, use the delete/channel and number keys to
enter the new area code. Then press select. A confirmation tone sounds.
To complete the setting, press end or return the handset to the base unit.
Choosing the dialing mode
Most phone systems use tone dialing which sends DTMF tones through the phone lines.
However, some phone systems still use pulse dialing such as in rural areas. The default
setting is tone dialing. Depending on your dialing system, set the mode as follows:
1) When the phone is in the standby mode, press and hold
cid/menu.
The following screen appears.
2) Press
4 or press the vol/ring/ key three times to select “Dial”.
3) Press
select to toggle between “Tone” and “Pulse”.
4) Press
end or return the handset to the base unit to complete the
setting. The handset returns to the standby mode.
Setting the language
1) When the phone is in the standby mode, Press and hold cid/menu.
The following screen appears.
2) Press
5 or press the vol/ring/ key four times to select
“
Language”.
3) Press
select to toggle between “Eng” and “Fr.”.
4) Press
end or return the handset to the base unit to complete the
setting. The handset returns to the standby mode.
• If you are not sure of
your dialing system,
make a trial call. If the
call connects, leave the
setting as is, otherwise
set for pulse dialing.
• If your phone system
requires pulse dialing
and you need to send
the DTMF tones for
certain situations during
a call, you may “switch-
over” to tone dialing
(refer to “Tone Dialing
Switch-over” on page
16).
EXAI398 2/5/3 4:11 PM Page 14