Filter
Top Products
www.uniden.com
[ 16 ] BASICS
• The tone feature only
applies when the dial
mode is set to pulse.
• This special number can
be stored in a memory
location. This is referred
to as Chain Dialing (see
page 22.)
Adjusting the Handset Ringer and Earpiece Volume
Handset ringer tone and volume
Press the volume up key or volume down key (labeled as, vol/ring/ and
vol/ring/ ) in standby mode to select one of five ringer tones and
volume combinations.
Earpiece volume
Pressing the volume up key or volume down key (labeled as, vol/ring/
and vol/ring/ ) during a call will change the earpiece volume of the
handset. This setting will remain in effect after the telephone call has ended.
Temporarily Mute Ringer
If the handset is off the base, simply press the end key to temporarily mute the incoming ring.
The ringer will sound with the next incoming call.
When you press the vol/ring/ key in Maximum mode or the vol/ring/ key
in Low mode, an error tone sounds.
Redial
The redial/pause key redials the last number dialed. The redialed number can be up to 32 digits
long.
Tone Dialing Switch-over
Some telephone companies use equipment that requires pulse dialing
(sometimes referred to as rotary dialing). If you need to enter tone dialing
digits, you can switch-over to tone dialing during the call. For example,
entering your bank account number after you have called your bank.
Initially make your call with the pulse dialing mode. Once your call
connects, press
*
/tone/ . Enter the desired number. These digits will be sent as tone dialing.
Once the call ends, the tone mode is canceled and pulse dialing mode resumes.
redial
pause
select memdelete
channel
EXAI398 2/5/3 4:11 PM Page 16