Filter
Top Products
GETTING STARTED [8]
www.uniden.com
B. Install the Rechargeable Battery Pack into the Handset
The handset is powered by a rechargeable battery pack.
The battery recharges automatically when the handset is
placed in the base unit.
1) Press down on the handset battery case cover (use
the finger indention for a better grip) and slide the
cover downward to remove.
2) Plug the battery pack connector (red & black wires)
into the jack inside the battery compartment. (The
connector notches fit into the grooves of the jack
only one way.) Match the wire colors to the polarity
label in the battery compartment, connect the
battery and listen for a click to insure connection.
3) Make sure you have a good connection by slightly
pulling on the battery wires. If the connection is
secure, the battery jack will remain in place.
4) Place the battery case cover back in the handset by
sliding it upwards until it clicks into place.
•Use only the Uniden
(BT-905) rechargeable
battery pack supplied
with your cordless
telephone.
•Replacement batteries
are also available
through the Uniden
Parts Department at
(800) 554-3988,
Monday through Friday
from 7:00 a.m. to 7:00
p.m., Saturday,
Sunday, and holidays
from 9:00 a.m. to 5:00
p.m., or online at
www.uniden.com
!
GETTING STARTED
UP033BH_EXI7246C.book Page 8 Wednesday, June 16, 2004 2:14 PM