Filter
Top Products
[7] GETTING STARTED
www.uniden.com
• Depending on the base location, there is a possiblity that the correct temperature and
humidity can't be displayed.
• Do not place any objects around the base.
• The base should be placed in a well-ventilated area.
• The location should be close to both a phone jack and a continuous power outlet (one which
is not connected to a switch).
• The base and handset should be kept away from sources of electrical noise such as motors,
microwave ovens, and fluorescent lighting.
• The base can be placed on a desk, tabletop, or mounted on a standard wall plate.
Outdoor Weather Sensor
The outdoor weather sensor monitors the outdoor temperature, air pressure, and humidity and sends
the received data to the base. Proper installation of outdoor weather sensors improves the accuracy
of the readings. Excessive heat, wind, and moisture can affect the sensor's readings. Follow the
guidelines below to get the most accurate information from your outdoor weather sensor:
• Do not mount the sensor in direct sunlight. Direct sunlight on the sensor will cause an
artificially high temperature reading.
• Do not mount the sensor where it will be exposed to rain and snow. Moisture on the sensor
may affect the temperature and humidity readings.
• Do not mount the sensor in the draft of an exhaust vent (e.g., from a heater, stove, or dryer).
• Do not mount the sensor above surfaces that radiate a lot of heat (e.g., bare concrete or blacktop). If
you can feel the temperature increase as you cross the surface, you should not put the sensor there.
• Try to avoid mounting the sensor close to plants or trees.
• Mount the sensor in a location where the airflow is representative of the surrounding area. If
the location of the sensor is unusually breezy or unusually still compared to the surrounding
area, the readings may be affected.
• Mount the sensor at least 60 inches above the ground.
• Mount the sensor 24 to 36 inches away from roof eaves, doors, or windows.
• If you are mounting the sensor above plants, the plants should be no higher than 10 inches above the ground.
• If your region gets snow, mounts the sensor at least 24 inches above the average maximum snow level.
• In the US and Canada, the north side of the building is considered the best location due to the angle of the sun.
GETTING STARTED
UP033BH_EXI7246C.book Page 7 Wednesday, June 16, 2004 2:14 PM