Filter
Top Products
[21] GETTING STARTED
www.uniden.com
6) Press the end key to complete the setting. The handset returns to standby mode.
Choosing the Dialing Mode (pulse vs. tone)
Most phone systems use tone dialing. However some phone systems (such as in rural areas)
still use pulse dialing. Your Uniden phone supports both tone and pulse dialing. The default
setting is tone dialing. If your phone system uses pulse dialing, follow the steps below to
change the dialing mode:
1) With the phone in standby mode, press and hold the call id/menu
key. The following screen appears.
2) Press the /vol/ key three times to select
Dial
.
3) Press the select key to set the phone to pulse dialing.
4) Press the end key to complete the setting. The handset returns to
standby mode.
Setting the Language (English, French or Spanish)
There are three languages to choose from: English, French and Spanish.
1) With the phone in standby mode, press and hold the call id/menu
key. The following screen appears.
2) Press the /vol/ key four times to select
Language
.
•If you are not sure of
your dialing system,
make a trial call. If the
call connects, leave
the setting as is.
Otherwise, set for
pulse dialing.
•If your phone system
requires pulse dialing
and you need to send
DTMF tones during a
call, you can
temporarily switch
over to tone dialing.
(Refer to “Tone Dialing
Switch-over” on
page 40.)
note
GETTING STARTED
UP033BH_EXI7246C.book Page 21 Wednesday, June 16, 2004 2:14 PM