Filter
Top Products
GETTING STARTED [24]
www.uniden.com
If the selected speed dial number is already assigned, the Edit
screen appears. You can select Edit to edit this entry, select
Delete to erase this entry, or select Go Back to choose another
speed dial number.
4) Enter a name according to the instructions below, then press the select key. If no name is
required, go to "Entering phone numbers" on page 25.
• The name can be up to 13 characters.
•Use the #/→ and
*
/tone/← keys to move the cursor to the desired location.
•Use the delete/channel key to delete characters as needed.
• Press and hold the delete/channel key to delete all the characters.
Refer to the letters on the number keys to select the desired characters.
With each press of a numeric key, the displayed character appears in the following order:
Upper case letters first, lower case letters next and finally the number corresponding to
the key.
If you make a mistake while entering a name
Use the
*
/tone/← or #/→ key to move the cursor to the incorrect character.
Press the delete/channel key to erase the wrong character. Then enter the correct
character. To delete all characters, press and hold the delete/channel key.
If the next character
uses the same number
key, you must press the
#/→ key to move the
cursor over. Otherwise
the next time you press
the number key, it
changes the character
that was previously set.
note
GETTING STARTED
UP033BH_EXI7246C.book Page 24 Wednesday, June 16, 2004 2:14 PM