Filter
Top Products
GETTING STARTED [10]
www.uniden.com
3) Install the Alkaline batteries into the battery
compartment observing the correct polarity. Make sure
the outdoor temperature and humidity appear on the
base display within five minutes. If the outdoor
temperature and humidity don't appear, switch the
Channel switch to another channel and remove the
batteries. Install the batteries again.
4) Replace the cover and tighten the knob with a screwdriver
or a coin.
5) Place the handset in the base unit with the keypad
facing forward. Set up the outdoor weather sensor
according to page 7.
6) Make sure the charge/in use LED illuminates.
If the LED does not illuminate, check to see that the
AC adapter is plugged in and the handset makes good
contact with the base charging contacts.
Charge your handset at least 15-20 hours before plugging into the phone line.
7) Once the handset battery pack is fully charged,
connect the telephone line cord to the TEL LINE
jack and a telephone outlet.
If your telephone outlet isn't modular, contact your
telephone company for assistance.
Modular
•Use only the Alkaline
batteries supplied with
your outdoor weather
sensor.
•The base LCD will blink
and prompt you to set
the time. See "A. Set
the Time" on page 14
for the instructions on
how to set the time.
•Once the outdoor
temperature and
humidity appear on
the base display, do
not change the
channel unless you
replace the batteries.
•Do not place the power
cord where it creates a
trip hazard or where it
could become chafed
and create a fire or
electrical hazard.
!
GETTING STARTED
UP033BH_EXI7246C.book Page 10 Wednesday, June 16, 2004 2:14 PM