Filter
Top Products
[11] GETTING STARTED
www.uniden.com
D. Mount the Outdoor Weather Sensor on a Wall
Follow the instructions below to mount the outdoor weather sensor on the wall. See page 7
to make sure you are mounting the weather sensor in the best location.
• Avoid electrical cables, pipes, or other items behind the mounting location that could
cause a hazard when inserting screws into the wall.
• Make sure the wall material is capable of supporting the weight of the outdoor weather
sensor.
• Use # 10 screws (minimum length of 1-3/8 inches) with anchoring devices suitable for the
wall material where the wall mount holder will be placed.
1) Thread a screw through two kinds of washers in accordance with the order as shown.
2) Insert the screw with the two washers into the wall with a little
looseness to fix the upper hole of the wall mount holder as shown.
3) Thread the other screw through two kinds of washers with the same
order in step 1, and then insert it into the lower hole of the wall
mount holder as shown.
4) Tighten both upper and lower screws using a screwdriver.
5) Insert the outdoor weather sensor in the wall mount holder.
1
2
3
GETTING STARTED
UP033BH_EXI7246C.book Page 11 Wednesday, June 16, 2004 2:14 PM