Filter
Top Products
Uninstalling a Previous Version
If you have been using an earlier version of Pocket CoPilot, you must uninstall the
application and its data before installing CoPilot. If you’re uninstalling CoPilot
from a Pocket device and installing the same version on another device, you must
deactivate the software on the first device before installing it again — see p. 12.
NOTE: When uninstalling CoPilot, your GPS receiver cannot be
attached. Before uninstalling, you must disconnect the receiver and perform a
soft restart. Then follow the steps outlined below:
(1) On your Pocket PC:
1. Tap the Start menu and select Settings>System>Remove Programs
2. Select the CoPilot application and tap Remove.
3. Select Pocket Speech and tap Remove.
4a. If you stored map data on a storage card:
i. Delete the CoPilot folder on the storage card. Tap Start, then Programs
> File Explorer > My Device > SD Card, then tap and hold on the CoPilot
folder and select Delete from the menu.
4b. If you stored map data on your device memory:
i. Delete the CoPilot folder on My Device.Tap Start, then Programs > File
Explorer > My Device, then tap and hold on CoPilot and select Delete
from the menu.
(2) On your Desktop/Laptop computer:
1. Select Start menu > Settings > Control Panel.
2. Double-click Add/Remove Programs.
3. Select the CoPilot application and click on the Remove button.
4. If asked to confirm the removal of CoPilot and all of its
components, selectYe s .
5. If asked to remove shared files during the uninstall process, select No
To All.
6. Select Start > Search > Files or Folders and find the CoPilot folder.
7. Right-click the CoPilot folder and select Delete.
Installing CoPilot
NOTE: You must uninstall any previous version of CoPilot from your
desktop/laptop and Pocket PC before proceeding (see above).
To install CoPilot, first turn on your computer and set up your Pocket PC.
Do NOT attach the GPS receiver yet, the application should not be
installed with the GPS receiver attached. Your Pocket PC should be
connected via ActiveSync, as described on p. 4.
Follow the steps below to install:
3. After accepting the Licence
Agreement, in the Installation
menu screen, make sure there
are check marks next to Pocket
PC Installation and Desktop
Installation. Click Next.
2. Enter your Product Key Code
when prompted, then click Next.
1. Insert the CoPilot Install Disc in
your CD-ROM drive. Have your
Product Key Code ready (you
can find it on your printed Quick
Start). Click Next in the
Welcome screen and follow the
Installation Wizard’s on-screen
instructions.
- 6 -- 5 -