Filter
Top Products
Toll Restriction
Program *45-4 – Special Code Dialing Sequence with LCR
4-28 Strata DK Programming 5/00
Program *45-4 – Special Code Dialing Sequence with
LCR
Processor Type: DK424, all RCTUs and BCUs (Release 4.1 and higher)
Program Type: Toll Restriction and LCR
Initialized Default: All LEDs Off
Program *45-4 Overview
When LCR is used to make calls, this program determines if the codes set in Program *45-3 are
sent before or after the digits that are set in the modified digits table (MDT). See Programs 55-1
and 55-0.
Program *45-4 only works when the code of Program *45-3x is dialed. The length of the pause
inserted is determined by the timer setup in Program 12-3 (unit pause length of 1.5 or 3 seconds).
This program has no effect on outgoing calls without Program *45-3 codes.
The digit deletion function of the modified digits table (Program 55-0) applies to the digits that
immediately follow the Front Modified Digits Table (F-MDT).
LED 01: Pause following Program *45-3 code
If LED 01 is On, a pause is inserted after the digits from Program *45-3 are sent; if LED 01 is Off,
a pause is not inserted.
LED 02: Order of LCR bypass code and MDT
If LED 02 is On, the code from Program *45-3 is inserted before the Front Modified Digits Table
(F-MDT) digits; if LED 02 is Off, code from Program *45-3 is inserted after the
F-MDT digits. (See example on Page -29.)
If LED 02 is On, digits are not deleted from the Program *45-3 code per Program 55-0; if LED 02
is Off, digits are deleted from the Program *45-3 code per Program 55-0.
✱ ✱ ✱ ✱6SNU✱ +ROG 6SNU +ROG 6SNU +ROG 6SNU +ROG
Button/LED X
LED On LED Off
20~3 Not used. Not used.
02
Sends the digits from Program *45-3 before
the Programs 55-1 Modified Digits Table
(MDT) digits.
Sends the Programs 55-1 Modified Digits Table
(MDT) digits before the digits from Program *45-
3.
01 Inserts a pause into the dialing sequence.
Does not insert a pause into the dialing
sequence.
SELECT = 4 Light the LED Buttons that are
marked with an X in the table below.