Toshiba DK40I Telephone User Manual


 
Toll Restriction
Program 42-1~8 PBX/Centrex Access Codes
4-10 Strata DK Programming 5/00
Program 42-1~8 PBX/Centrex Access Codes
Processor Type: DK14, DK40i, all RCTUs and BCUs
Program Type: Toll Restriction
Initialized Default: Assigns no access codes to PBX groups
Program 42-1~8 Overview
The Centrex access code(s) used to make out-of-centrex calls (usually 9) is entered in this table.
Use this program to allow correct Toll Restriction and Centrex/PBX transfer operation.
Do not use this program when using LCR behind Centrex/PBX; use Program 45-2 instead. Also,
do not use this program if installing CO lines behind assume-9 Centrex.
   6SNU +ROG 6SNU +ROG 6SNU +ROG 6SNU +ROG
PBX/Centrex Access Code
Number
PBX/Centrex Outgoing CO Line Access Code(s)
1st Digit 2nd Digit
1
2
3
4
5
6
7
8
ACCESS CODE = Enter a 2-digit access code for the group,
as defined by the table below.
If access code is single digit, enter the first digit and press
LED Button 01 as second digit.
Press LED Button 01 to delete digit.
Press LED Button 02 for Wild Card digit (any digit, 0~9). For
example, pressing
8 + LED Button 02 allows 80~89.
SELECT = 1~8 PBX Access Code Group
Enter the PBX Group Number 1~8 that needs
an access code assigned.