System & Station
Program 30 – Station Class of Service
Strata DK Programming 5/00 3-77
System & Station
Program 30 Overview
Program 30 enables or disables features for individual telephones at the station level. The
following text describes Program 30 LEDs.
LED 20: SLT/ISDN Terminal “#” Dial
This feature applies to single-line telephones and ISDN station terminals to indicate when a
number has been dialed and to begin dialing a sub-address. If a
is dialed as the first digit, it
indicates that a feature access code is being entered.
For ISDN, if separate dialing and sub-address digits will be used, turn LED 20 On. If it is Off,
can be used as a dialing separator.
LED 19: Privacy Override
With Privacy Override enabled (LED 19 On), a station can override calls and listen to a CO line
conversation by pressing a common CO
/LQH button (not a [DN] button). [DN] buttons are always
private. A maximum of two stations can override an existing “station-line” conversation. You can
set a warning tone for Privacy Override (see Program 10-2).
Privacy Override of Direct Inward System Access (DISA) Two-CO line calls is not allowed.
Privacy Override is not available on any call (CO line or internal) that appears on a [PDN], [SDN],
or [PhDN] button.
Block Privacy Override by a station via a
3ULYDF\ button (Program 39) or with the Executive/
Privacy Override blocking option (Program 31, LED 18). To configure the Strata DK system to
operate as nonprivate, allow Privacy Override from all stations. Disabling Privacy Override for
attendant console ports does not deny Attendant Supervised Loop Monitoring.
LED 18: Executive Override
With Executive Override enabled (LED 18 On) a station can break into and overhear an existing
station conversation by pressing
after the busy station number or by pressing the “EXEOVR”
LCD soft key. You can set a warning tone for this feature (see Program 10-2).
Privacy Override can be perform from stations with Executive/Privacy Override blocking enabled
in Program 31, LED 18. The
3ULYDF\ button does not block Executive Override. Disabling
Executive Override for attendant console ports does not deny Attendant Supervised Loop
Monitoring.
LED 17: Do Not Disturb (DND) Override
With DND Override enabled, (LED 17 On), you can override a station that has DND On. A called
station with DND activated will return very fast busy tone (four tones per second). If the caller
presses
after dialing the DND station directory number, a DND Override tone is heard on the
called station’s speaker.
If a DND station has more than one [PDN] and it appears on other telephones, when called, the
[PDN] rings at the other telephones and flashes on the DND station. In this case, DND override is
not available unless all [PDNs] of the DND station are busy.
LED 16: Change Toll Restriction Traveling Class Code
When LED 16 is On for a port, the station occupying it can change the four-digit Toll Restriction
Traveling Class of Service Codes established in Program 44-1~8. Stations selected for this feature
must follow the dialing sequences below to change the codes:
Class 1 #691 Class 5 #695
Class 2 #692 Class 6 #696
Class 3 #693 Class 7 #697
Class 4 #694 Class 8 #698
[PDN] + class code (~) +four-digit code + 5HGLDO