Filter
Top Products
Step 4: Install Wall Mounted Phones (Continued)
7
5 Assign a Station Number
Refer to page 8 for detailed instructions on
assigning a station number.
6 Install Batteries (Optional)
It is not necessary for you to install batteries in
your Epic telephone for it to function normally.
In fact, batteries are not even needed to pre-
serve your memory dial numbers in the event
of a power failure. This is because all memory
dial numbers are stored in a static memory
which retains its contents even with no electri-
cal power. The only purpose of having batter-
ies installed is so that the telephone itself can
function on line 1 only for up to twelve hours in
the event of a power failure. You may wish to
install batteries in at least one Epic phone for
emergency operation, or have another stan-
dard phone available. If you wish to install bat-
teries, refer to page 68 for detailed instructions.
7 Attach Telephone to Wall
Hold the telephone close to the wall and con-
nect the short telephone line cord to the jack.
Then mount the telephone to the wall plate,
sliding it down firmly so that it locks securely in
place.
8 Verify Proper Installation
IMPORTANT: Please remember to perform the
procedure on page 9, after you assign each
station number, to verify that each telephone is
properly installed.
Installing Your System
EV4500 UG combined v52 in PDF order 101005.qxd 10/10/2005 4:53 PM Page 21