Filter
Top Products
69
Setting Toll Saver On/Off
To set Toll Saver on/off:
1
Press P.
- The display will read
“Program...”
2 Press the soft key under ANSW.
3 Press the soft key under NEXT
repeatedly, until ”Toll Saver”
appears in the display, along with
the current setting.
4 Press the soft key under CHANGE
repeatedly, until the desired Toll
Saver setting is displayed.
The choices are:
Toll Saver: ON
Toll Saver: OFF (factory setting)
5 Press P to exit.
The Toll Saver feature helps you eliminate toll
charges when calling in to check for messages
by letting you know if there are any new mes-
sages before the phone answers. When Toll
Saver is turned ON, the answering system will
pick up incoming calls after the second ring if
there are new messages, or after the fourth ring
if there are no new messages. In that case you
would hang up after the third ring to avoid the toll
charge.
Note: The Toll Saver feature overrides the
Answer Pickup Delay setting. Also, if this phone
is set as an Auto Attendant, the Toll Saver fea-
ture overrides the Auto Attendant Pickup Delay
setting. So, for example, if you have set the Auto
Attendant Pickup Delay to “0” rings, because you
want a quiet office, you must keep the Toll Saver
set to OFF.
The Toll Saver feature can
help reduce toll charges
Answering System
Setting Up and Operating Your Telephone’s Answering System
Toll Saver: ON
BACK CHANGE NEXT
EV4500 UG combined v52 in PDF order 101005.qxd 10/10/2005 4:53 PM Page 83