Filter
Top Products
Step 3: Install Desk/Table Top Phones (Continued)
5
3 Connect Handset
Plug either end of the coiled handset cord into
the handset and the other end into the jack on
the side of the telephone. Place the handset in
the cradle.
4 Connect Power Cord
Plug the AC power cord into the adapter jack
on the bottom of the telephone. Thread the
power cord into the recessed groove. Plug the
AC adapter into an electrical outlet not con-
trolled by a wall switch.
5 Assign a Station Number
Refer to page 8 for detailed instructions on
assigning a station number.
6 Install Batteries (Optional)
It is not necessary for you to install batteries in
your Epic telephone for it to function normally.
In fact, batteries are not even needed to pre-
serve your memory dial numbers in the event
of a power failure. This is because all memory
dial numbers are stored in a static memory
which retains its contents even with no electri-
cal power. The only purpose of having batter-
ies installed is so that the telephone itself can
function on line 1 only for up to twelve hours in
the event of a power failure. You may wish to
install batteries in at least one Epic phone for
emergency operation, or have another stan-
dard phone available. If you wish to install bat-
teries, refer to page 68 for detailed instructions.
7 Verify Proper Installation
IMPORTANT: Please remember to perform the
procedure on page 9, after you assign each
station number, to verify that each telephone is
properly installed.
Installing Your System
EV4500 UG combined v52 in PDF order 101005.qxd 10/10/2005 4:53 PM Page 19