Filter
Top Products
INSTALLING THE SVMi-4
Inspection
Unpack and inspect the unit for obvious damage. This card should be labeled
SVMi-4. If it is not, you have the wrong card.
Installation
The SVMi-4 card is installed in any 2X4 slot in either the DCS 50si or the DCS
Compact. The first thing you should do before proceeding is to discharge any
static electricity you may have gathered by touching a ground point such as the
cover of the KSU Power Supply. When you have done this then check the power
switch on the KSU and ensure that the switch is in the OFF position. Next posi-
tion the SVMi-4 card in the grooves of the card guide, and gently slide the card
in until it makes contact with the connector. Press gently but firmly on the top
and bottom of the front edge of the card until the card seats in its connector.
All the power to run this self contained Voice Mail system comes from the
phone system power supply. No special power considerations are necessary The
KSU can now be turned on.
The final step is to press the reset button on the front of the SVMi-4.
Installation - Page 35